![]() ![]() 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45).1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44).1A12A2U3 - Unit 1, Assembly 12, Sub-assembly 2, Inseparable Assembly 3Įspecially valuable is the method of referencing and annotating cables plus their connectors within and outside assemblies.1A12A2R3 - Unit 1, Assembly 12, Sub-assembly 2, Resistor 3.Inseparable assemblies-i.e., "items which are ordinarily replaced as a single item of supply" -are typically treated as components in this referencing scheme. ![]() Note that IEEE-315-1975 defines separate class designation letters for separable assemblies (class designation 'A') and inseparable assemblies (class designation 'U'). Any number of sub-assemblies may be defined until finally reaching the component. Subsequent demarcation are called assemblies and always have the Class Letter "A" as a prefix following by a sequential number starting with 1. The unit is the highest level of demarcation in a system and is always a numeral. It breaks down a system into units, and then any number of sub-assemblies. This standard, along with IEEE 315–1975, provide the electrical designer with guidance on how to properly reference and annotate everything from a single circuit board to a collection of complete enclosures.ĪSME Y14.44-2008 and IEEE 315-1975 define how to reference and annotate components of electronic devices. To replace IEEE 200–1975, ASME, a standards body for mechanical engineers, initiated the new standard ASME Y14.44-2008. This standard codified information from, among other sources, a United States military standard MIL-STD-16 which dates back to at least the 1950s in American industry. This document also has an ANSI document number, ANSI Y32.16-1975. ![]() The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter. IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. For example, the letter R is a reference prefix for the resistors of an assembly, C for capacitors, K for relays. IEEE 315 contains a list of Class Designation Letters to use for electrical and electronic assemblies. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. The reference designator usually consists of one or two letters followed by a number, e.g. Location identifier for a circuit componentĪ reference designator unambiguously identifies the location of an component within an electrical schematic or on a printed circuit board. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |